Expendable Pattern Casting, Lost Foam Casting Process-bloxorz

Business Expendable pattern casting process is also called as lost foam casting process, which is adapted to cast steel, cast iron, cast aluminum and other metal castings, and large, medium and small castings of different structures and a variety of materials. Characters of EPC Expendable pattern casting process uses dry sand to mold and duplicate the prototype. The geometry of castings is of high precision, and there is no flash, burrs, cold shut, and the surface finish is close to the precision casting. The metal castings cast by expendable pattern casting equipment have stable internal structure and the blisters, air space, shrinkage and other casting defects are ruled out. This process makes full use of the idea of environmental protection, and the entire production process does no damage to the environment. Expendable pattern casting is a new precise forming process of almost non-margin. This process does not need to take the mold, it has no parting and no sand core, thus the castings have no flash, burrs and taper angle, and the size error caused by core portfolio is also reduced, which can significantly reduce the machining costs, and .pared with the traditional sand casting methods, the machining room can be reduced by 40 % to 50%. Short.ings of EPC Like other casting process, expendable pattern casting also has its short.ings and limitations, not all metal castings are suitable for expendable pattern casting (EPC) process, specific analysis should be carried out. Whether to adopt this technology is mainly based on the following factors. 1. Casting volume The greater the volume is, the more substantial economic benefits will be. 2. Casting materials The applicability of casting material is roughly in the following order (from good to bad): Grey iron – non-ferrous alloy – ordinary carbon steel – ductile iron – low carbon steel and alloy steel; With necessary preparations, the technical experiments and debugging cycle will not be too long. 3. Casting size We should mainly consider the use scope of the equipment (such as tap sets, sand boxes). 4. Casting structure The structure of metal castings is more .plex, the more it can reflect the superiority of EPC technology and its economic benefits. For the structure of a narrow cavity channel and sandwich case, a pre-experiment is required before the use of EPC, and then it can be put into production. This article was from Dandong Foundry. For the whole article, please check Dandong Foundry Blog. About the Author: 相关的主题文章: